Setting the water hardness level
The display will change to the screen
for setting the water hardness.
- You should programme the dish-
washer to the correct water hardness
for your area.
- Your local water authority will be able
to advise you of the water hardness
level in your area.
- Where the water hardness fluctuates
e.g. between 1.8 and 2.7 mmol/l (10 -
15 °dH - German scale) always pro-
gramme the dishwasher to the higher
value (2.7 mmol/l or 15 °dH in this ex-
ample).
In the event of a fault, it will help the
service technician if you know the hard-
ness of your local water supply.
Therefore, please enter the water hard-
ness:
____________°dH or mmol/l
The dishwasher is programmed at the
factory for a water hardness level of
2.5 mmol/l (14 °dH – German scale).
Set the water hardness level in your
area and confirm using OK.
See the "Settings" chapter, "Water
hardness" section for more informa-
tion.
en - Before using for the first time
Prompts will then appear in the display.
After confirming these prompts with
OK, the messages
Refill rinse aid
Add salt and rinse aid if necessary
(see the "Dishwasher salt" and "Rinse
aid" sections in the "Before using for
the first time" chapter).
Select OK to confirm the messages.
The programme selected will appear
briefly in the display and the appropri-
ate sensor control will be illuminated.
Next, the estimated water consumption
may be shown for the chosen pro-
gramme for several seconds.
Then the display will show the estim-
ated running time for the programme
selected.
Refill salt
and
may appear.
45