Panasonic WUME-SF4D-2 Instruction Manual page 9

♦ Machine designer, installer, employer and operator
● The machine designer, installer, employer and operator are solely responsible to ensure
that all applicable legal requirements relating to the installation and the use in any appli-
cation are satisfied and all instructions for installation and maintenance contained in the
instruction manual are followed.
● Whether this device functions as intended to and systems including this device comply
with safety regulations depends on the appropriateness of the application, installation,
maintenance and operation. The machine designer, installer, employer and operator are
solely responsible for these items.
♦ Engineer
● The engineer would be a person who is appropriately educated, has widespread knowl-
edge and experience, and can solve various problems which may arise during work, such
as a machine designer, installer or employer etc.
♦ Operator
● The operator should read this instruction manual thoroughly, understand its contents, and
perform operations following the procedures described in this manual for the correct op-
eration of this device.
● In case this device does not perform properly, the operator should report this to the person
in charge and stop the machine operation immediately. The machine must not be operated
until correct performance of this device has been confirmed.
♦ Environment
● Do not use a mobile phone or a radio phone near this device.
● If there exists a reflective surface in the place where this device is to be installed, make
sure to install this device so that reflected light from the reflective surface does not enter
into the receiver, or take countermeasures such as painting, masking, roughening, or
changing the material of the reflective surface, etc. Failure to do so may cause the device
not to detect, resulting in death or serious injury.
● Do not install this device in the following places:
1) Areas exposed to intense interference (extraneous) light such as high-frequency fluo-
rescent lamp (inverter type), rapid starter fluorescent lamp, stroboscopic lights or direct
sunlight.
2) Areas with high humidity where condensation is likely to occur
3) Areas exposed to corrosive or explosive gases
4) Areas exposed to vibration or shock of levels higher than that specified
5) Areas exposed to contact with water
6) Areas exposed to too much steam or dust
♦ Installation
● Always keep the correctly calculated safety distance between this device and the danger-
ous parts of the machine.
● Install extra protection structure around the machine so that the operator must pass
through the sensing area of this device to reach the dangerous parts of the machine.
● Install this device such that some part of the operator's body always remains in the sens-
ing area when operator is done with the dangerous parts of the machine.
● Do not install this device at a location where it can be affected by wall reflection.
● When installing multiple sets of this device, connect the sets and, if necessary, install
some barriers such that mutual interference does not occur. For details, refer to "2-3-4
Preventing Mutual Interference".
● Do not use this device in a reflective configuration.
© Panasonic Industrial Devices SUNX Co., Ltd. 2016
WARNING
Introduction
9