Polaris RZR XP Service Manual page 220

EFI / FUEL SYSTEM
10. Install the plastic rivets
ing the center console.
specification.
TORQUE
Body Screws:
8 ft-lb (11 Nm)
11. Connect the fuel supply line
the fuel pump.
NOTICE
There is no return line on EVAP models.
4.30
e r
and Torx screws retain-
Torque fasteners
q w
and return line
12. If the fuel pump cover was fully removed, push the
to chassis side fuel pump electrical connector through
the "+" shaped pass-through of the fuel pump cover
next to the fuel line opening.
13. Connect the fuel pump electrical harness.
The harness protection tape must be pushed all the
way through the cap opening. If the wires are not
to
protected from the cap by the harness protection tape,
they will wear through over time.
The connectors will be housed in the cap when properly
installed. Do NOT pull the pump flying lead connector
through the "+" cutout.
14. Orient the fuel pump cover so that the fuel lines pass
through the opening, and push down around the
edges to ensure the cover is fully engaged around the
pump nut.
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
CAUTION
NOTICE
© Copyright Polaris Industries Inc.