Inserting The Needle; Attaching And Removing The Presser Foot Holder - Silvercrest SCNM 100 A1 Operating And Safety Instructions Manual

Before starting up

Inserting the needle

C

Attaching and removing the presser foot holder

A
1
18 EN
E
D
A
B
B
WARNING!
Set the main power switch to the "0 OFF" position.
Change the needles regularly, especially at the first signs of prob-
lems when sewing.
Insert the needle:
1. Loosen the needle clamp screw (A).
2. Insert the new needle with the flat side of the shaft facing
backwards (B).
3. Insert the needle (C) up to the stop at the end of the shaft (D).
4. Tighten the needle clamp screw again.
NOTE
Only use needles that are in perfect condition. Problems can
occur with bent needles, blunt needles and damaged tips.
WARNING!
Set the main power switch to the "0 OFF" position.
NOTE
The presser foot holder is pre-installed.
1. Attach the presser foot holder:
E
Raise the presser foot bar (A) by lifting the two-step presser
foot lever (22). Attach the presser foot holder (B) as illustrat-
ed.
2. Remove the presser foot holder:
Raise the presser foot bar (A) by lifting the two-step presser
foot lever (22). Loosen the screw and remove it. Pull the
presser foot holder (B) down from the presser foot bar (A).
D
2
C
a