Husqvarna AUTOMOWER 450X Operator's Manual page 20

Note:
ECO mode to save energy and prevent
Use
interference with other equipment, for example hearing
loops or garage doors.
Note:
To start the product manually in the work area,
push the STOP button before you remove the product
from the charging station. If not, the product cannot park
at the charging station.
3.9.5 Accessories
Settings for accessories mounted on the product can be
made in this menu.
3.9.5.1 Headlights
There are 4 different headlight settings that control when
the headlights are on:
Always on
•
• Evening only (19:00-00:00)
Evening and night (19:00-07:00)
•
Always off
•
The headlights flashes if there is an error.
Note:
Husqvarna recommends to use the headlights
at night time.
3.9.5.2 To avoid collisions with the Automower
When this option is enabled, the wear on the product
®
and the Automower house is reduced, but it can result
in more uncut grass around the charging station.
3.9.6 General (Bluetooth
This function is used to set time and date, or to reset to
default settings.
3.9.6.1 Time & date
The time and date can be changed manually, or by
using the time and date from the mobile device.
3.9.6.2 Reset to factory settings
The user settings can be reset to factory settings. All
map objects and the schedules will be deleted.
20 - Installation
®
house
®
only)
Note:
PIN code, Loop signal, Messages and Date &
Time will not be reset.
3.9.7 Security (Bluetooth
The security settings controls the PIN code, the
GeoFence and other security functions. The correct PIN-
code must be entered to get access to the
®
menu in the Automower Connect app.
3.9.7.1 New loop signal
The loop signal is randomly selected to create a unique
link between the product and the charging station. In
rare cases, there may be a need to generate a new
signal, for instance if 2 adjacent installations have a very
similar signal.
3.9.7.2 Change PIN code
You can change the PIN code in the Automower
Connect app. Make a note of the new PIN code in
Introduction on page 6 .
Memo. Refer to
3.9.7.3 Theft protection
Theft protection menu it is possible to set the
In the
alarm duration and also what events should trigger the
alarm. The factory setting is to require PIN code and the
alarm duration is 1 min.
Require PIN code
This function means that the product cannot be operated
or controlled after the STOP button has been pushed
without first entering the correct PIN code. If the
incorrect PIN code is entered 5 times, the product is
locked for a time. The lock is extended for each new
incorrect try.
Alarm duration
There is a possibility to set how long the alarm signal
should last. A setting between 1 and 10 minutes is
possible.
STOP button pressed
"STOP button pressed" is enabled, the
If the alarm
alarm goes off if someone presses the STOP button and
the PIN code is not entered within 30 seconds.
Carried away
If the alarm Carried away is enabled, the product senses
unexpected motions, and the alarm goes off.
3.9.7.4 GeoFence
GeoFence is a GPS-based theft protection that makes a
virtual fence for the product. If the product is more than
a set distance away from the center position the product
will be deactivated and an alarm will start. The center
position will be set to the current position of the product
when the function is enabled. The PIN code is needed to
®
only)
Security
®
1970 - 001 - 10.10.2022