Installing The Module On A Din Rail; Removing The Module From The Din Rail - GE VersaMax GFK-2721A Manual

Installing the Module on a DIN Rail

Removing the Module from the DIN Rail

1. If the module is attached to the panel with a screw, remove the screw.
2. Slide the module along the DIN rail away from the other modules until the connector
disengages.
3. With a small flathead screwdriver, pull the DIN rail latch tab outward while tilting the other
end of the module down to disengage it from the DIN rail.
GFK-2721A
The PROFINET Scanner and connecting carriers must be installed on
the same section of 35mm x 7.5mm DIN rail. The rail must have a
conductive (unpainted) finish for proper grounding. For best
resistance to vibration, the DIN rail should be installed on a panel
using screws spaced approximately 6 inches (5.24cm) apart.
Modules snap easily onto the DIN rail. No tools are required for
mounting or grounding to the rail.
Chapter 2 Installation
2
2-5