Power Supply Board
Processor Board
3. Reconnect the ground cable with screw and washer.
4. Reconnect the flat cable from the processor board.
5. Connect power switch manipulator.
To remove the Processor Board, first follow the instructions for dismantling
the Receiver, then:
Removing the Processor Board
1. Remove the flat cable to the Power Supply Board (A).
2. Remove the cable to the Front Panel Board (B).
3. Remove the flat cable connector (C).
4. Using a M6 spanner, remove the coax cable (D).
5. Using a M5 spanner, remove the 2 hexagonal screws (E) at the 25 pin
D type connector. (See next picture).
Chapter 7 - Replacing Parts