Dismantling The Receiver - Philips 50 T Series Service Manual

Dismantling the Receiver

Chapter 7 - Replacing Parts
5. Check switch mechanism is set at O (off).
6. Connect the top housing to the bottom housing and snap the two
parts together.
7. Screw the housing together carefully (do not press hard).
8. Replace the batteries.
9. Switch on and ensure that the green On LED is lit. Also check the red
LED inside the battery compartment (situated behind the middle
battery) by lifting the battery cover.
To dismantle the Receiver:
1. Turn the Receiver off and disconnect from power supply.
2. Remove antenna.
3. Remove 4 screws (A).
4. Slide top cover from back to front until it stops.
5. Lift off.
Dismantling the Receiver