Head Installation; Installation Direction - Panasonic LP-RF Series Setup & Maintenance Manual

2-3 Head Installation

WARNING
„ Carrying head part
• To carry this product, wear the non-slip gloves. Hold the product with both hands. Do not hold the fiber unit, cables or
connectors at carrying.
• Do not touch the laser emission port on the bottom of the head. It may affect the marking quality badly.
• Carry this product as shown in the figure below.

2-3-1 Installation direction

The head can be installed to up, down, left, and right directions.
• Do not move the head unit during the operation.
• When the product is installed with the laser emission port facing upward, dust generated during marking may attach to
the laser emission port, impairing marking quality and damage the product. Clean the laser emission port periodically
according to the head installation conditions and environment.
• Be sure to fix the bottom surface (the laser emission port side).
• Make sure that the power is turned OFF at installing. Failure to do so may
cause electrical shock.
• Install the product so that the laser beam path does not cross the eye height.
• The laser beam path shall be enclosed with protective enclosure and make
sure it is not exposed with direct light or reflected light.
Laser pointer
emission port
Fiber unit
Laser emission port
ME-LPRF-SM-11
37