Advertisement
4. NetWare Driver Installation
4. NetWare Driver Installation
The ASUS PCI-DA2000 Series drivers diskette contains the following driver files
for NetWare v3.1x, v4.0x and v4.1 respectively:
In sub-directory netware\v3_1x:
-ASUSASP.DSK:ASPI manager for NetWare v3.1x
-DA2000.DDI: Installation Information File.
-DA2000.DSK: Disk Driver for NetWare v3.1x
In sub-directory netware\v4_x:
-ASUSASP.DSK:ASPI manager for Netware v4.0x and v4.1
-DA2000.DDI: Installation Information File.
-DA2000.DSK: Disk Driver for NetWare v4.0x and v4.1.
4.1.
Installing NetWare v3.1x
Follow these procedures to install ASUS PCI-DA2000 drivers for Netware v3.11 or
v3.12.
1 Use ASUS PCI-DA2000 Series BIOS Configuration Utility to disable ISA Mail-
box Emulation mode (default is disabled). To do this, at system bootup, press
[Ctrl-I], select Configure Card option, then change IO Port Address to DIS-
ABLED.
2 Use ASUS Text RAID Manager or RS-232 Terminal Interface Operation to con-
figure Logical Drives and SCSI Devices and map them to valid SCSI-IDs/LUNs.
Note that SCSI ID 7 is reserved for the ASUS PCI-DA2000 Series adapter
and thus no logical drives or devices should be mapped to this SCSI ID.
3 Plug one or up to four ASUS PCI-DA2000's Series into host PCI slots then
power on. ASUS PCI-DA2000 Series BIOS will show the following messages
on the screen for each installed ASUS PCI-DA2000 Series:
ASUS PCI-DA2000 Series (PCI-TO-SCSI RAID) BIOS v1.11
PCI Bus # = 00 Device # = 0A Port = E800 IRQ = 11 EDORAM = 4MB FW=v1.12
!! Press <Ctrl><I> for Configuration Utility, <Q> to Skip !!
4 Make sure the RAID configuration is properly set. (Refer to section 4 Text
RAID Manager and RS-232 Terminal Interface Operation).
ASUS PCI-DA2000 Series RAID Controllers Driver Installation
49
Advertisement
