Kenwood SIRIUS KTC-H2A1 Instruction Manual page 15

15, 30 or 60 minutes). This is especially useful if your vehicle's cigarette lighter remains powered after the
ignition has been turned off.
1. While in the Setup Mode, press the left or right arrow button until the Auto Shutoff Setup screen appears (below).
2. Press the up or down arrow buttons until the display
shows amount of time you want Here
2
stay on after the last time a button is pressed before
it automatically shuts off.
• When Auto Shutoff is activated, a 'beep' will sound and
the screen will display a countdown warning 10 sec-
onds before Here Anywhere shuts itself off. Pressing
2
any button during this countdown will cancel the Auto Shutoff process and restore normal operation.
3. Press the POWER button to exit.
Sleep Timer
You can program Here Anywhere to play for 30 or 60 minutes and then automatically turn itself off.
2
Note: You must re-set the Sleep Timer each time you want to use it.
1. While listening to SIRIUS, press the SELECT button to
enter the Stream List mode (see page 18).
2. Hold the left arrow button for at least 1 second. The
Timer Setup screen will appear (right).
3. Press the left or right arrow button to highlight the
28
Anywhere to
Auto Shutoff Setup Screen
Timer Setup Screen
Here Anywhere Instruction Manual (ver. 2)
2
amount of time you want Here Anywhere to play before it shuts off.
2
4. Press the SELECT button to confirm your selection and activate the Sleep Timer.
When the Sleep Timer is active, the display will return to the Normal Operation screen.
• The display will appear as normal except that every three seconds the timer countdown will replace the
stream number. You can still change streams and display modes as normal without shutting the timer off.
To cancel the Sleep Timer, turn Here Anywhere's power off, then turn it back on again.
2
Channel Skip/Lock
This allows you to select streams that you want to skip when scanning up and down the Channel List and
Category List screens, or simply when you're pressing the cursor up & down buttons.
1. While in the Setup Mode, press the left or right arrow
button until the Channel Skip screen appears (right).
2. Use the up & down arrow buttons to highlight the
stream you want. (The highlighted stream will
automatically play.)
3. Press the SELECT button to change the highlighted
stream's status from "available" (+) to "skip" (–).
• To exit the Channel Skip function, press the left or right arrow button. The screen will display the next
Setup Menu item.
You can further lock a stream by placing it in the Channel Lock mode. Locked streams will be unavailable
during all tuning modes, and cannot be directly accessed via the remote control.
Here Anywhere Instruction Manual (ver. 2)
2
Channel Skip Screen
29