Mitsubishi Electric KD Series User Manual page 65

5-2 Setting ③ Select output format
5-2-3 Pixel-data Output setting
【 Input 】
Command Parameter End code
OC ** CR
[Initial setting] 10bit- 2Tap Output Base Configuration
without Pixel interpolation and Overlap
[settings]
Output data depth 8bit / 10bit
Output arrangement Single/parallel
Output Configuration and No. of channel
Camera Link®
Base / Medium / Medium x2 / Medium x3
Pixel interpolation On/Off
Pixel Overlap On/Off
Example
Select format : 10bit 2Tap / single output
/ Base Configuration
/ without pixel interpolation & Overlap
OC 00 ＜ CR ＞ ⇒ 00 00 <CR>
TM-XG537C
【 Output 】
Result Parameter End code
** ** CR
COPYRIGHT © 2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
【 Pixel-data Output setting 】
[Function]
Image data output format is set by this command .
The bit Depth of image data is selected from 8 and 10 bit
width .
1) There are 2 mode of output data alinement as following.
- Single output : Image data is output from 1
end pixel of taps sequentially .
- Parallel output : Image data of Odd and even pixels
of taps is output at a same time .
2) Output format is based on Camera Link® standard and
correspond to Base and Medium Configuration.
3) The function of pixel interpolation and overlap is
available . A1 and A0 size CIS can output each as 2
and 3 of A3 size CISs .
Detail information are shown in Appendix A .
【 Remarks 】
1) The functions , Output format , line frequency and Pixel
clock frequency, are related each other . Therefore set
them carefully .
Camera Link® is a registered trademark of AIA(Automated Imaging Association)
st pixel to
65