Kenwood SG-5260 Instruction Manual page 25

1) When t h e MOD key @) i s p r e s s e d ,
MODULATION display and the ENT key' s LED flashes.
2) While the ENT key' s LED i s flashing, use the numeric keys to enter the
desired modulat ion value.
key @ to erase the d i g i t s one by one s t a r t ing from the l a s t input.
Then enter, then correct value.
3) When the modulation value has been input, press the ENT key.
ENT key i s pressed, the output l e v e l value displayed on the display i s
set.
* I f a modulation set value exceeding the range of the u n i t ' s r a t i n g s i s
entered, the modulat ion d i s p l a y value wi 11 r e t u r n to the modulation
value v a l i d before the input.
* During direct setting, do not press the keys other than the numeric keys
on the front panel.
* I f the ENT key i s not pressed a f t e r the set value has been input and
whi le the LED i s f l a s h i n g , the set value r e t u r n s to the value v a l i d
before the input when the M O D key ©
d i g i t s a r e e r a s e d
I f a wrong d i g i t i s entered, press the BS
i s pressed again.
from t h e
When the