Installation and setting
Function check
If a maIfunction occurs a message is indicated at the display, see "Service Instructions,
section Display messages".
Functional test cable winder
•
Disconnect the power plug
•
Pull the left brake handle (for the cable winder) upwards.
•
Pull it down and up until cable is completely rolled up.
•
Pull out the cable and connect the power plug.
Functional tests with motor drive
?
•
Test the forward/ reverse and fast (1 m/s) / slow (0.5 m/s) controls.
NOTICE
Speed Adjustment (if necessary)
•
Remove the plastic plug of tilt bar below the front cover (for details see service instruc-
tions).
•
Use a screwdriver and adjust the speed by potentiometer on D101:
- turn clockwise (CW) for slower speed.
- turn counterclockwise (CCW) for faster speed.
NOTICE
Siemens-Elema AB
Solna, Sweden
For adjustment, see chapter "Speed Adjustment".
This will effect the slow/fast speed simultaneously.
SPR8-220.033.01
Rev. 05
Page 3 of 10
05.01
SPS-UD
2 - 3
2
2
2
2
MOBILETT Plus HP