Troubleshooting - Electrolux PA21G Instruction Manual

7. Troubleshooting

Customer Service
If the appliance presents any malfunction,
before calling the Authorized Service, check
below if the cause of the failure is not a
simple one to solve or if there is no error in
the use of the product, which can easily and
Faults
Doesn't work / won't turn
on
Water with odor and/or
taste
Water leakage
No water comes out
The water doesn't freeze
The "Filter replacement"
indicator does not go off.
10
Possible Causes
Outlet with bad contact.
Power failure, circuit breaker
off or blown fuse.
The product has not been
used for more than 3 days.
Odor coming from the
product's water pipe.
The appliance indicating the
need for filter replacement.
Loose pipe connection.
Damaged connectors or
hose.
Tap or water supply closed.
Filter not properly fitted.
Water pressure is too low.
Check the UV lamp indicator
(for PA31G only).
Check the air filter.
Check the installation.
Clogged water filter before
the time indicated in the
Manual.
No more water in the cold
water tank.
The water filter replaced with
the product switched off.
quickly be corrected, without waiting for a
technician.
When the suggested corrections are not suf-
ficient, call the Electrolux Authorized Service,
which will be at your disposal.
Correct the fault in the power outlet.
Wait for the power to return, turn on the
circuit breaker or change the fuse.
Dispose of approximately 5 liters from
each tank (ice-cold and natural) before
consuming the water again.
Clean the product as instructed on Pages
8 and 9.
Replace the filter.
Make sure that the appliance's water pipe
connections have been properly secured.
Please contact the Electrolux Authorized
Service.
Open the tap or water supply.
Fit the filter correctly.
Make sure the water pressure is above 4
mca (39 kPa).
Replace the UV lamp (for PA31G only).
Clean the air filter.
The product must not be embedded,
placed inside cabinets or places without
ventilation.
Check your hydraulic installation, clean
the system such as water tanks and pipes,
or contact your water supply company.
The storage capacity of the cold water
tank is 800 ml. The Peltier electronic
cooling system has a cooling recovery
time of up to two and a half hours,
depending on factors such as ambient
temperature, inlet water temperature and
frequency of use.
Replace the water filter with the product
switched on.
Corrections