Mitsubishi Electric MELSERVO-J2 Series Instruction Manual page 154

7. DISPLAY AND OPERATION
2) 5-digit parameter
The following example shows the operation procedure performed to change the electronic gear
denominator (parameter No.5) into "12345":
Call the display screen shown after power-on.
Upper 2 digit setting
When changing the parameter No.5 setting, change its set value, then switch power off once and
switch it on again to make the new value valid.
(2) Expansion parameters
To use the expansion parameters, change the setting of parameter No.19 (parameter write disable).
Downloaded from ManualsNet.com
Press once. Select parameter No.5 with
MODE
Press once.
SET
Press once.
MODE
Press once.
SET
The screen flickers.
Change the set value
with or
UP DOWN
Press once.
SET
The set value is
entered.
Press once.
SET
Press
search engine
UP
Lower 3 digits setting
.
or .
UP DOWN
To the next parameter
7 - 9
or .
DOWN