Table of Contents
Advertisement
Setting up
To deactivate access control:
1
Select "Disable", and click "Setting".
This allows access from a PC that has been
configured with any IP address.
To activate access control:
1
Select "Enable", and click "Setting".
This allows access only from a PC that has
been configured with one of the set IP
addresses.
2
Enter the IP address to be registered,
and then click "Add IP address".
This registers the IP address to which access
is permitted.
Click on "Delete" next to an IP address that
has already been registered to delete that
address.
Caution
Enter an IP address using one of the following formats:
• xxx.xxx.xxx.xxx (xxx = 0-255)
• xxx.xxx.xxx.xxx/yy (xxx = 0-255, yy = 0-32)
Self-diagnostic program
Upon clicking "Self-diagnostic program", the
following screen is displayed. This screen is used
to perform a variety of self-diagnostic tests.
1
Click on the process to be performed.
The test will begin.
Restart of dsnetm
"dsnetm" is a program used to communicate
between the TCP/IP sockets on the unit and a
host PC.
Upon clicking "Restart of dsnetm", the following
screen is displayed.
Click "Restart" to restart dsnetm and display the
restart status. After completing the restart, the
following screen is displayed.
23
Setting up
Advertisement
Table of Contents
