Table of Contents
Advertisement
Part names and usage
q; System initialize button
While holding down this button, pressing the
on/standby button (1) returns the
communication processor software to the factory
default initial state.
qa Network initialize button
While holding down this button, pressing the
on/standby button (1) restores the factory
default values for the IP address settings.
qs DVD-ROM drive
This drive accepts DVD-ROM discs. Use the
open/close button (9) to insert and remove
discs.
Unit rear
1
2
EXT
3
4
FOOT SW
5
6
L
7
AUDIO
OUT
R
8
RF ( EXT )
9
q;
DC IN
19.5V
qa
qd Controller port
Connects with the commander interface
connector of the attached controller.
qf GPO indicator
These are eight indicators that are user-definable
TM
by PSP
software developers.
qg Headset connector
The PSP-1000 series headphones with remote
control or a commercially sold headset (with a
stereo mini-plug) can be connected here.
qh GPI switch
These are eight dip switches that are user-
definable by PSP
TM
software developers.
1 Aerial
For wireless LAN use.
2 Extension connector
For use by service personnel only.
3 Dedicated connector for servicing
For use by service personnel only.
Caution
Usage of this port may cause irreparable damage to the
system.
4 Foot switch connector
Connects to the supplied foot switch.
5 Network connector
Connector for a network cable. Allows
connection to a local area network.
6 VGA connector
Connects to a device with a VGA IN connector.
7 AUDIO OUT connector
Connects to a device with an AUDIO IN
connector.
8 Vent fan
Vent for internal fan used to cool unit. Be sure
not to obstruct this vent, as doing so may cause a
fire. Also, to prevent any hindrance to air flow,
position the unit an adequate distance from walls.
11
Part names and usage
Advertisement
Table of Contents
