Table of Contents
Advertisement
Rear Panel
Reference: Cooling device (aluminum)
If the LED head is not mounted on a jig, the LED head can become hot during irradiation.
Warning
For this reason, do not touch it directly with your hands during irradiation.
Procedure
1
Remove the protective cap on the main unit
2
Plug in the connection cable.
3
Plug the connection cable into the LED head.
4
Remove the protective cap on the LED head.
Set the LED jig in place.
Warning
Note: The LED head is made of aluminum.
Care is required, because if you tighten it
directly with set screws using too much
strength when it is secured in a jig, you
may cause it to deform.
Note: LED can be used with a light-modulation
ratio of 100% or greater, by increasing
the size of the cooling device and/or
cooling the LED head.
Getting Started
(screw for securing LED)
13
Advertisement
Table of Contents
