Samsung Smart MBS RRH-C2A Installation Manual page 63

5) Remove the cable gland nut from the power cable input hole located at the bottom of
RRH-C2A.
6) Insert the cable gland nut to the power cable (Hybrid cable, AWG8, 2C).
7) Insert the power cable from the bottom of the equipment through the power cable input
hole, then install within the power window. Make sure that the power cable's unsheathed
part is inserted only as far as the protruded section inside the rain protection sponge.
8) Turn the screws(On the power terminal block) 8 times or more by the opposite direction
of clockwise rotation. So, clamp of the bottom must be moved down completely.
9) Inset power cable(Sheath is stripped) with the correct polarity, fasten the screw by torque
14 kgf.cm.(Refer to the 'Caution for connecting power cable to terminal block')
© SAMSUNG Electronics Co., Ltd.
Smart MBS RRH-P4 Installation Manual/Ver.2.0
2-31