Husqvarna BG 250 Operator's Manual page 44

b) For BG 250Petrol, remove the bush hammer
tools. The BG 250Petrol must not be tilted for a
longer time.
c) When the accessories bush hammer tools or
cutters are installed, the level of vibration
increases.
To install and remove the bush hammer tools
1. Hold the handlebar and tilt the product rearward. Tilt
the product until the handlebar is on the floor.
2. Install the bush hammer tools on the tool plate.
3. Tighten the bolt to a torque of 60 Nm.
4. Remove the bush hammer tools in the opposite
sequence.
To install the cover for the bush hammer tools
The cover for the bush hammer tools is an accessory.
1. Put the cover for the bush hammer tools on the dust
cap.
2. Install the 4 bolts, the 4 washers and the 4 locknuts.
3. Push the cover down to the surface and tighten the 4
bolts.
To install the LONG startup support
The LONG startup support is an accessory.
44
1. Remove the screws, the washers and the startup
support from the product.
2. Install the LONG startup support, the washers and
the screws on the product.
1802 - 002 - 13.04.2022