Table of Contents
Advertisement
After changing the jets
^ Reassemble the burner parts in the
reverse order.
^ Check all gas fittings for leaks by
operating the burner without the
upper section of the cooktop in place
(use a match to ignite the flame).
^ Remove the loose burner parts again.
^ Replace the upper section of the
cooktop.
^ Screw the burner bases into place,
and replace the other parts of the
burner. Take care to reassemble the
different parts in the correct order.
^ Replace the control knob.
^ Finally ignite all the burners to check
that they are operating correctly.
Conversion to another type of gas
The flame must not go out on the lowest
setting, or when the control is turned
quickly from a high to a low setting.
On the highest setting, the flame must
have a distinctive and visible core.
^ Adhere the label supplied with the
jets above the label stating the type
of gas being used.
47
Advertisement
Table of Contents
