Table of Contents
Advertisement
^ Make the worktop cut-out following
the dimensions applicable.
Remember to maintain a minimum
safety clearance from the back wall,
as well as from any tall unit or side
wall to the right or left of the
appliance.
See "Safety clearances".
^ Seal the cut surfaces with a suitable
heat-resistant sealant to avoid
swelling caused by moisture.
The materials used must be
heat-resistant.
If, during installation, you find that the
seals on the corners of the frame are
not flush with the worktop surface,
the corner radius (ß R4) can be
carefully scribed to fit.
Preparing the worktop
31
Advertisement
Table of Contents
