General Information
Lift Roller Position
The cutting unit comes with its lift roller installed in the
top position. The position of the roller may be changed
as follows:
1. Remove hex head screw and lock nut from the lift
roller and frame.
2. Position lift roller to the proper hole on the frame. In-
sert hex head screw through the frame and roller.
Lower Hole – for increased transport height.
Upper Hole – standard transport height so the cut-
ting unit is level when it touches down upon lower-
ing.
3. Secure hex head screw with the lock nut.
Grass Basket Removal and Installation
1. Grasp basket by top rear lip and slide on or off the
basket mounting rods.
Cutting Units
1. Lift roller
1
1. Grass basket
1
1. Grass basket
Page 8 – 4
1
2
Figure 2
2. Hex head screw
2
Figure 3
2. Mounting rod
2
Figure 4
2. Mounting rod
Greensmaster 3200/3200–D