Installation (Fig. 58)
1. Make sure formed hoses and openings of the oil
cooler are clean.
2. Remove plugs from oil cooler openings.
3. Hang oil cooler onto cooler brackets while attaching
the formed hoses to the cooler. Secure hoses by tighten-
ing the hose clamps.
4. Clean radiator screen and reinstall.
Greensmaster 3200/3200–D
5. Remove clamps that where used to prevent drain-
age from the formed hoses.
6. Fill hydraulic tank (see Check Hydraulic System
Fluid).
7. Start machine. Run machine at idle for 3 to 5 min-
utes to circulate hydraulic fluid and remove any air
trapped in the system. Stop machine and recheck hy-
draulic tank level.
Page 5 – 75
Hydraulic System