Writing Manually During Playback (Rehearsal Function) - Sony DAT DTC-690 Operating Instructions Manual

1, 3
)
7
1
1
3
2
1
3
WRITE
START ID
A
a)
∞
c)
d)
f)
f)
32
£ 8
$ › 1 ¡
• ¶
2
WRITE
START ID
\
¡
START ID
START ID
WRITE
SKIP ID
REHEARSAL
S
END ID
a)
b)
c)
e)
Start ID
Writing Manually during
Playback (Rehearsal Function)
During playback, start ID can be written at
the desired position more accurately than
during recording.
Make sure that the safety tab of the
cassette is closed.
1
Press the 3 3 3 3 3 button to start
playback. At the desired position,
press the START ID WRITE button.
The REHEARSAL indicator lights and
the WRITE and START ID indicators
flash, and the position for 3 seconds
from the point where you pressed the
START ID WRITE button is played
back repeatedly (rehearsal function).
The beginning of the repeated portion
will be the beginning of the start ID.
2
Press the 1 1 1 1 1 or ¡ ¡ ¡ ¡ button to ¡
adjust the "repeat start" point.
The "repeat start" point is shifted
backward with the 1 button or
forward with the ¡ button by about
0.3 of a second.
The indicator at the MARGIN display
shows how much the "repeat start"
point is shifted from the point where
you pressed the START ID WRITE
button.
3
After setting the beginning of the
start ID at the desired point, press
the START ID WRITE button again.
The WRITE indicator lights steadily
and the start ID is written. The
program number is not written in this
time.
a) When you pressed ¡ twice.
Note on the point where a start ID is
written Å
During the rehearsal function, a start ID is
written at the beginning of the repeated
portion as illustrated.
a) Point where you pressed START ID
WRITE
b) Repeated portion (for 3 seconds)
c) Selection
d) Each time you press 1
e) Each time you press ¡
f) 0.3 sec.
Normally, the repeated portion is played
back 5 times.
When the 1 or ¡ button is pressed
while the repeated portion is played back,
the repeated portion is played back up to 8
times max, and then the tape stops.