Finishing Backlapping
Important:
If you do not return the backlap switch
to the O
position after backlapping, the cutting
FF
units will not raise or function properly.
1.
Shut off the engine and remove the key.
2.
Wash all lapping compound off from the cutting
units.
3.
Adjust the cutting unit reel-to-bedknife as
needed.
4.
Rotate the backlap levers to the F (mow)
position.
Figure 123
1. Backlap lever (front cutting
units 4, 1, and 5)
2. Backlap lever (rear cutting
units 2 and 3)
5.
For a better cutting edge, run a file across the
front face of the bedknife after lapping.
Note:
This removes any burrs or rough edges
that may have built up on the cutting edge.
6.
Close and latch the hood; refer to
Hood (page
42).
g370556
3. Forward rotation (mow)
Closing the
Extended Maintenance
Chassis and Engine
Service Interval: Every 2 years—Replace the
hydraulic hoses.
Every 2 years—Replace the coolant hoses.
Every 2 years—Flush and replace the coolant.
71