Haier HB WH-Filter M10 Manual page 25

StArt
26:45
rEG On
26:45
rEG On
SEt
4 .....08:32
Day of week
I = Monday
2 = Tuesday
3 = Wedesday
i.e. 5 .....07:43
5 .....07:43
Start-up backwashing
●Insert mains plug.
●Water supply must remain closed.
●The display shows StArt and then alternates
between the capacity and day of the week (1-7) /
time.
●Allow basic fixing to finish (approx. 40 sec.) The
running noise stops.
●An automatic backwashing starts.
●Slowly open the water supply to set the unit under
pressure.
The display alternates between:
–remaining backwashing time in minutes (with a
flashing symbol)
–rEG On
At the end of the backwashing the flushing water
must look clear. If it does not look clear, repeat the
backwashing.
Repeat backwashing
Press OK about 4 sec. until the backwashing starts.
The display alternates between:
–remaining backwashing time in minutes (with a
flashing symbol)
rEG On
Setting time and day
Press Browse
Flashing digits can be changed
Changes the numbers Moves the cursor
Set day of the week
Press Browse
Press OK
The programming is complete.
The unit is ready.
7 7