Led Indicators; Isp Settings; Connect The System; Connect The Adsl Line - Philips CPWBS154 Instructions For Use Manual

LED
PWR (Power)
xDSL (DSL sync)
Online
WL (Wireless)
LAN 1-4

LED Indicators

The power and port LED indicators on the front panel are illustrated by
the following figure and table.
Status Description
On Power on, normal operation.
Off Power off or failure.
On ADSL loop is brought UP.
Blinking Start up.
Off ADSL loop is down.
On Link is up.
Blinking Send/Receive data.
Off No data transfering.
On Link is up.
Blinking Send/Receive data.
Off No data transfering.
On Ethernet Connection is established.
Blinking Send/Receive data.
Off Without Link.

ISP Settings

Please collect the following information from your ISP before setting up the
ADSL Wireless Base Station:
• ISP account user name and password
• Protocol, encapsulation and VPI/VCI circuit numbers
• DNS server address
• IP address, subnet mask and default gateway (for fixed IP users only)

Connect the System

The ADSL Wireless Base Station can be positioned at any convenient
location in your office or home. No special wiring or cooling requirements
are needed.You should, however, comply with the following guidelines:
• Keep the ADSL Wireless Base Station away from any heating devices.
• Do not place the ADSL Wireless Base Station in a dusty or wet environment.
You should also remember to turn off the power, remove the power cord
from the outlet, and keep your hands dry when you install the ADSL
Wireless Base Station.

Connect the ADSL Line

Connect the supplied RJ-11 cable from the ADSL Microfilter/Splitter to the
ADSL port on your ADSL Wireless Base Station. When inserting an ADSL
RJ-11 plug, be sure the tab on the plug clicks into position to ensure that it
is properly seated.
PWR XDSL On Line WL L1 L2 L3 L4
ENGLISH
8