Nokia IP1200 Series Installation Manual page 43

4. Check the power LED (the Nokia logo) on the front panel of the appliance
The power LED should be illuminated. For more information about the
system status LEDs, see
If the fans are not running, or if the power LED is not illuminated, make sure:
If the fans are still not running, or if the power LED does not illuminate,
contact your Nokia service provider or Nokia Support as listed in
Contact Information"
Note
On an appliance with two active power supplies installed, connect and
turn on both power supplies for load sharing and redundancy. If two
power supplies are installed and both power supplies are not turned on,
the Fault LED illuminates.
Nokia IP1200 Series Security Platform Installation Guide
The fan unit on the power supply turns on when you press the power
switch. Verify that the power supply fans are running after you press the
switch.
Note
The IP1200 Series power supply automatically detects the input
voltage (115 VAC or 220 VAC [85 to 264]) and configures itself
appropriately.
to ensure that the power supply is operating correctly.
The power cord is properly connected.
The power supply switch is on.
The chassis assembly is pushed all the way in from the front of the
appliance.
That power is turned on to the power strip or wall receptacle into which
you plugged the appliance.
on page 3 for technical support.
Connecting Power and Turning the Power On
"System Status LEDs" on page 28.
"Nokia
43