Table of Contents
Advertisement
1
Overview
hard disk drive contains a copy of all of the files on the source hard disk drive,
and if the source hard disk drive fails, the mirror hard disk drive immediately
takes over. The IP1200 Series continues to operate normally, and the
switchover to the secondary mirror drive should be transparent to your data
connections.
You can use Nokia Network Voyager, the command-line interface (CLI), or
Lynx to create and delete mirror sets.
Note
If your IP1200 Series contains two hard disk drives when you receive it,
the disk-mirroring feature is already enabled.
For more information about disk mirroring, including configuration details,
see the Nokia Network Voyager Reference Guide and the IPSO Release Notes
and Getting Started Guide for the version of IPSO you are running.
Hard-Disk Drive Hot Swap Feature
If you configure disk mirroring, you can use the hot swap button, shown in
Figure
down. For information about how to remove and replace a hard disk drive, see
"Replacing a Hard Disk Drive"
Hard-Disk Drive LEDs
The hard-disk drive LEDs are located on the front panel of each hard disk
drive, as shown in
drives as described in
30
6, to remove or replace a hard disk drive without shutting the system
Figure
6. The LEDs provide the status of the hard disk
Table
Nokia IP1200 Series Security Platform Installation Guide
on page 120.
5.
Advertisement
Table of Contents
