Mitsubishi Electric MELSEC-Q Series User Manual page 161

Device Item
Execution/
(S1)+0
abnormal end type
(S1)+1 Completion status
(a) Control data
b15
1) Execution type (bit 0)
0: Without arrival confirmation
• When the target station is on the same network
The process is completed when data is sent from the own station.
1: With arrival confirmation
The process is completed when data is written in the target station.
When "0: Without arrival confirmation" is specified, the result is regarded
as normal on the own station even if the writing to the target station fails,
as follows.
• When communication ends normally even though sent data are
abnormal
2) Abnormal end type (bit 7)
Specify the data set status in case of abnormal end.
0: After (S1)+11, no data is set for abnormal end.
1: After (S1)+11, data for abnormal end is set.
The status of the instruction completion is stored.
0: Normal
Other than 0: Error (Refer to Section 12.5.)
Chapter 10 DEDICATED INSTRUCTIONS
Setting data
to b7 to
0 2) 0
Request Target
source station
Completed
Request Target
source station
Completed
10 - 23
Setting range
b0
1)
0000H
0001H
0080H
0081H
–
Set by
User
System