Black & Decker BDFH44M Instruction Manual page 31

TROUBLESHOOTING & WARRANTY
SYMPTOMS
Shuts off before
load is dry
Odors remain
in clothing after
refresh
Garments still
wrinkled after
Wrinkle-prevent
Lint on clothes
" " is lighting
" " is flashing
Degree of
dryness was
not reached or
drying time too
long
- Household odors from painting, varnishing, strong cleaners,
etc. may enter the dryer with surrounding room air. This is
normal as the dryer draws the air from surrounding air space
of the dryer locations.
- When these odors linger in the air, ventilate the room
completely before using the dryer.
- Fabrics containing strong odors should be washed utilizing
desired wash cycle.
- Small loads of 1 to 4 items work best.
- Load fewer garments. Load similar-type garments.
- Lint filter should be cleaned before every cycle. With some
loads that produce high amounts of lint, it is necessary to
clean the filter after the cycle.
- Some fabrics are lint producers (for example, a fuzzy white
cotton towel) and they should be dried separately from
clothes that are lint trappers (for example, a pair of lack linen
pants).
- Divide larger loads into smaller loads for drying.
- Check pockets thoroughly before washing and drying clothes.
- Clear lint filter.
- When the cycle is end, " " will flash and dryer will beep 5
seconds.
- Check the water container. If it's full, please pour out the
condensate water and restart the dryer.
- If the container is not full, please restart the dryer directly.
- If the "water full" icon is still flashing after you have finished
the first two steps, please call the service.
- Clean lint filter.
- Empty container.
- Check drain hose.
- Dryer installation place is too restricted.
- Clean the moisture sensors.
- Keep the Air inlet clean.
- Use higher drying intensity level program or time program.
SOLUTIONS
Page 31