Philips ITS4843B Installation Manual page 33

Caution Do not kink the RA Coax-and-UTP-cable-bundle during installation. You must
maintain a minimum 2.5-inch (64-mm) bend radius for the RA Coax-and-UTP-cable-
bundle throughout the installation.
a) Connect the first Remote Antenna to the Core AP using the UTP and Coaxial
b) Connect the second Remote Antenna to the Core AP using the UTP and
c) Be sure to label the UTP cable bundles and the Remote Antennas
IntelliVue Smart-hopping
Figure 2-3: 1.4 GHz IntelliVue Smart-hopping Core AP and Remote Antenna Controls
5. Route a Category 5e (or higher) RJ-45 cable between each IntelliVue Smart-
hopping Core Access Point and the equipment closet in which the IntelliVue
Smart-hopping infrastructure devices are installed.
-
-
6. Install a ferrite block on the RJ-45 cable within 20 inches (50 cm) of the RJ-45
connector that connects to the Core Access Point as shown in Figure 2-2.
IntelliVue Smart-hopping 1.4 GHz Access Point Installation Guide
cable connectors labeled RA 1 in Figure 2-1.
Coaxial cable connectors labeled RA 2 in Figure 2-1.
themselves as RA 1 and RA 2 corresponding to the cable connections you
made in steps a and b.
Link LED Activity LED
Power/Sync, Radio,
Ethernet Interface to
and Network
Status LEDs
Connection LED
(Green)
UTP Cable Connector
to IntelliVue Smart-hopping
ITS4843B and ITS4843C Access Points use Unshielded Twisted Pair cables.
ITS4843D Access Points require Shielded Twisted Pair cables to protect the
system from power line transients.
ITS4843B and ITS4843C Installation Procedure
IntelliVue Smart-
hopping Core Access
RA 2 RA 1
Serial Port
IntelliVue Smart-hopping
Remote Antenna
to IntelliVue Smart-hopping
and Connectors
Coaxial Cable Connectors
to Remote Antennas (2 & 1)
RA 2 RA 1
UTP Cable Connectors
to Remote Antennas (2 & 1)
with RA Status LEDs
Power LED
(Yellow)
Coaxial Cable Connector
Core Access Point
2-7