Philips ITS4843B Installation Manual page 30

Chapter 2: Installing the IntelliVue Smart-hopping 1.4 GHz Core Access Point
Caution Do not kink the RA Coax-and-UTP-cable-bundle during installation. You must
maintain a minimum 2.5-inch (64-mm) bend radius for the RA Coax-and-UTP-cable-
bundle throughout the installation.
a) Connect the first Remote Antenna to the Core AP using the Fiber and Ferrule
b) Connect the second Remote Antenna to the Core AP using the Fiber and
c) Be sure to label the UTP cable bundles and the Remote Antennas
Ethernet Interface to
IntelliVue Smart-hopping
Ferrule Cable Connector
to IntelliVue Smart-hopping
Figure 2-1: 1.4 GHz IntelliVue Smart-hopping Core AP and Remote Antenna Controls
5. Route a Category 5e (or higher) RJ-45 cable between each IntelliVue Smart-
hopping Core Access Point and the equipment closet in which the IntelliVue
Smart-hopping infrastructure devices are installed.
-
-
6. Install a ferrite block on the RJ-45 cable within 20 inches (50 cm) of the RJ-45
connector that connects to the Core Access Point as shown in Figure 2-2.
2-4
cable connectors labeled RA 1 in Figure 2-1.
Ferrule cable connectors labeled RA 2 in Figure 2-1.
themselves as RA 1 and RA 2 corresponding to the cable connections you
made in steps a and b.
Link LED Activity LED
Power/Sync, Radio,
and Network
Status LEDs
Sync Unit
Core Access Point
ITS4843B and ITS4843C Access Points use Unshielded Twisted Pair cables.
ITS4843D Access Points require Shielded Twisted Pair cables to protect the
system from power line transients.
IntelliVue Smart-
hopping Core Access
Point
RA 2 RA 1
Serial Port
IntelliVue Smart-hopping
Remote Antenna
Power LED
(Yellow)
and Connectors
Ferrule Cable Connectors
to Remote Antennas (2 & 1)
RA 2 RA 1
Fiber Cable Connectors
to Remote Antennas (2 & 1)
with RA Status LEDs
Fiber Cable Connector
to IntelliVue Smart-hopping
Core AP
Connection LED
(Green)