Mounting Tank Assembly To Machine Or Tractor - Pioneer APPLI-PRO DASIC Manual

4. Drill holes and mount the gauge holder in a location that can be seen from the operator's station.
5. Cut a length of hose (002-9003AS) that will reach from the pump discharge to the remote mounted
gauge. Attach one end to the pump discharge and the other to the intake barb fitting on the gauge
assembly. Secure both ends with hose clamps.

MOUNTING TANK ASSEMBLY TO MACHINE OR TRACTOR

Note: modification or fabrication may be needed for your specific machine.
MOUNTING to the BALER, FORAGE HARVESTER, or other MACHINE
- Locate a large enough flat area in-which the tank can be bolted to the machine. If there is not
enough space you will have to fabricate one. Please keep in mind the weight of the full tank.
- Position so you can see the pressure gauge and be able to operate both the mixing valve and
shut off valve.
-
MOUNTING to the TRACTOR
- This is highly recommended if you have the 55 gal system. You will need to fabricate some
brackets to do this.
Step 5
6
Step 5