Scenario 4: Change Setpoint By Means Of Logo! Td; Scenario 5: Display Values By Means Of Logo! Display - Siemens LOGO! 0BA7 Manual

6 Operating the Application
6.5

Scenario 4: Change setpoint by means of LOGO! TD

The following section describes how to change the setpoint value.
Table 6-5
No.
Press the "F4" button in the LOGO! TD to increase
1.
the setpoint value by "1".
Keep the "F4" button pressed to continuously
increase the setpoint value.
Press the "F1" button in the LOGO! TD to decrease
2.
the setpoint value by "1".
Keep the "F1" button pressed to continuously
decrease the setpoint value.
The FAQ "How can I increment/decrement a setpoint value using the function
Note
keys of LOGO! TD?" provides a better understanding of changing the setpoint
via function keys "
http://support.automation.siemens.com/WW/view/en/34914500
6.6

Scenario 5: Display values by means of LOGO! Display

By means of the display integrated in the LOGO! logic module, the process values
are displayed as bar diagrams.
Table 6-6
No.
1. Bar display of the process values in the LOGO! logic
module display
A bar display of 100% corresponds to
•
SP: 2500 mbar
•
PV: 2500 mbar
•
Pump: 1350 revolutions per minute
Set23_RegSim
Entry ID: 23753479, V2.3.S,
Action
Action
02/2014
Comments
Comments
29