Table of Contents
Advertisement
∗2) BREAKAGE OF LCD PANEL
DO NOT INGEST liquid crystal material, DO NOT INHALE this material, and DO NOT PERMIT this material to
contact the skin, if glass of LCD panel is broken.
If liquid crystal material contacts the skin, mouth or clothing, take the following actions immediately.
In case contact to the eye or mouth, rinse with large amount of running water for more than 15 minutes. In case
contact to the skin or clothing, wipe it off immediately and wash with soap and large amount of running water for more
than 15 minutes. The skin or closing may be damaged if liquid crystal material is left adhered.
In case ingestion, rinse out the mouth well with water. After spewing up by drinking large amount of water, get medical
treatment.
∗3) GLASS OF LCD PANEL
BE CAREFUL WITH CHIPS OF GRASS that may cause injuring fingers or skin, when the glass is broken.
The LCD module has the structure where a plastic film is stuck on a glass surface and glass cannot disperse easily.
However, touching a cut surface may cause injuries.
4) ABSOLUTE MAXIMUM RATINGS
DO NOT EXCEED the absolute maximum ratings specified in this Specification. These are the rated values that
must not exceed for a LCD module by any means. Since the parts used as a circuit are damaged by fire or breakage
and the characteristic may not be recovered when exceeding this rating, take into consideration the variation in
ambient temperature, input signal change, and dispersed specification of electric parts etc., and design not to exceed
LCD module absolute maximum ratings.
5) POWER PROTECTION CIRCUIT
Employ protection circuit for power supply, for LCD module failures according to the operating condition of a set.
A suitable protection circuit should be applied, based on each system design.
DO NOT MODIFY the fuse used in the LCD module.
It may cause overheating and/or fire, if dust or metal particles touch the PCBs or failures of some circuits occur in the
LCD module.
6) DISPOSAL
Always comply with all applicable environmental regulations, when discarding the LCD module.
7) EDGES OF PARTS
Be careful with handling the metal flame (bezel) of a LCD module. Even though deburring treatment is performed, it
may cause injury. Be careful with edges of glass parts and touch panel identically. For designing the system, give
special consideration that the wiring and parts do not touch those edges.
Toshiba Matsushita Display Technology Co.,Ltd
Specification No. TENTATIVE
Date: 2008 – 11- 07
Date:
New No. LTA057A341F-14
Old
-
-
No.
←# Special
←& Addition
Sheet
3
← Change
Advertisement
Table of Contents
