Troubleshooting - Bosch BI.7101 Series User Manual And Installation Instructions

17 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
If the appliance is defective, call Customer Service.
▶
WARNING ‒ Risk of electric shock!
Incorrect repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
17.2 Malfunctions
Fault
The appliance is not
working.
The appliance is
switched on. The op-
eration indicator does
not light up.
The operation indic-
ator flashes.
The cookware or
food is not heating
up.
The cookware or
food does not get
warm enough.
The appliance
switches off. and
light up.
Cause and troubleshooting
The circuit breaker in the fuse box has tripped.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other appliances are working.
▶
Open the appliance.
1.
Following a power cut, the touch fields light up in ascending order from left to right.
The display goes out after approx. 30 seconds and the appliance is ready for operation.
Start the required operating mode.
2.
The operation indicator is defective.
Call the after-sales service.
▶
→ "Customer Service", Page 14
The appliance heats up.
Wait until the appliance has finished heating up.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other appliances are working.
▶
The appliance is switched off.
Switch the appliance on.
▶
The warming drawer is not completely closed.
Close the warming drawer.
▶
The cookware covers the ventilation system slots and the appliance switches on the over-
heating protection.
Do not place the cookware directly in front of the ventilation system slots on the rear
▶
panel of the appliance.
There has been a power cut.
Check whether the lighting in your kitchen or other appliances are working.
▶
The cookware or food has not been heated for long enough.
Heat the cookware or the food for a longer period of time.
▶
The warming drawer is not completely closed.
Close the warming drawer.
▶
The appliance has overheated.
Wait until the appliance has cooled down.
1.
2. Ensure that the ventilation slots on the rear panel of the appliance are not covered.
Check whether an oven integrated above is in pyrolytic self-cleaning mode.
3.
Only use genuine spare parts when repairing the
▶
appliance.
If the power cord of this appliance is damaged, it
▶
must be replaced with a special connection cable,
which is available from the manufacturer or his Cus-
tomer Service.
17.1 Fault indicator
In the event of a fault, the operation indicator flashes
quickly. A signal tone sounds. When you open the ap-
pliance, symbols light up on the control panel, depend-
ing on the cause.
Touch any touch field to switch off the signal tone. If
you then touch , the display goes out.
Troubleshooting en
13