Advertisement
Names of Parts and Their Functions (Fig. 1)
Heating Dimple Head (titanium material)
The device vibrates while being used in
modes other than "Cool."
Mode Indicator Lamp
Mode
During preparation
Orange lamp
HOT CLEANSING
flashing
HOT MOISTURIZE
HOT MASK
Blue lamp flashing
COOL
Mode Switch Button
Every time the button is pressed, the
mode for use will be switched.
Power Switch (" ")
Turn on the power switch, and it will turn
"On." Press it again, and it will turn "Off."
An automatic shutoff function is equipped,
so if the device is not used for around 3
minutes, it will automatically turn "Off."
Body Socket
Body
Level Indicator Lamp
[ L ] LOW (green): [ M ] MEDIUM (green):
[ H ] HIGH (red)
When the power switch is switched to
"On," the lamp indicating "HIGH,"
"MEDIUM," or "LOW" is turned on.
Level Switch Button
Every time the button is pressed, "the
strength" of the electrical potential will
change. There will be no change in
vibration strength.
Charge Indicator Lamp
Lights in red when charging and turns
off after charging is completed. Flashing in
red is a signal requesting a charge.
Preparation Before Use
How to Charge
●
Since this is not fully initially charged, charge before first use.
●
Make sure to use only 100-240V and use the included power adaptor.
Do not insert and remove the power plug from an electric outlet with
wet hands. (Cause of electric shocks and short-circuits)
Do not use in places splashed with water, such as in a bath,
or in damp places. (Cause of failures or short-circuits)
1. Turn off the switch, and connect the power adaptor to the main body and electric outlet.
Charge indicator lamp
(Fig. 2)
During charge : The lamp turns on. (Red)
After charging is completed : The lamp turns off.
Buzzer (Switching sound/ready
sound/warning sound/abnormality
detection sound/finish sound/
indicating timer sound)
Every time the switch or button is
During use
pressed, the switching sound will beep.
Orange lamp
When the preparation is completed in
lights
"Cool" mode, the ready sound will beep.
The warning sound will beep to indicate
Blue lamp lights
the continuous use of "Cool" mode.
In the event of a failure, an abnormality
detection sound will beep. When each
mode is finished, the finish sound will
beep.
Cooling Head (aluminum material)
Apply this head to your skin in "Cool"
mode.
Back Plate (titanium material)
Touch this part and apply the heating
head to your skin in modes other than
"Cool," and the device will start to
operate. It will not vibrate if you remove
your hand from this plate.
Battery (built-in)
Lithiumion battery 1 pc.
Power Adaptor
Model: KH-155B
Power Plug
Cord
Rings (two) : Rings for attaching cotton.
Protective Cap
Spot Sensor
The sensor senses a spot and indicates
it by the vibration strength (Low, High).
It does not sense a spot when cotton is
attached.
-4-
Instrument Plug
Accessories
Advertisement
