Advertisement
CAUTION
Unless you apply the cotton to your skin while touching the back plate, the device
will not vibrate. (skin sensing function)
If the heating dimple head is not vibrating, the device is not working.
If you leave the device as it is for about 3 minutes without vibration, the device will
automatically switch "Off." (Automatic shutoff function)
Indicating Timer Function
Skin care time is indicated by the buzzer beeping about every 45 seconds as a guide.
[Example of skin care sequence] (Fig. 9)
Divide the area from your face to décolletage into four zones as shown in the
illustration. By moving the heating dimple head in the order of ①②
③
④décolletage, the whole area can be efficiently and uniformly cared for.
●
Apply cotton gently to the face and slowly move the device by sliding it from the
center of the face to the outer side.
●
Add more toner when there is no moisture in the cotton or when the device is
difficult to slide.
●
Do not apply the device on the same area of skin for more than 10 seconds.
●
If you feel your skin tingling by micro current while using the device, press the level
switch button and switch to "L."
If you still feel your skin tingling, use the device by adding more toner.
6 After 3 minutes have elapsed, the device will automatically shut off.
(Auto shutoff function)
●
The finish sound will inform you.
7 Remove the ring and the cotton.
Wipe off the surface of the heating dimple head with a tissue.
●
●
Do not use the cotton again once it is used. It might cause problems with your skin.
Step 2
"HOT MOISTURIZE"
This mode cares for skin by allowing moisturizing ingredients of toner permeate into
the skin.
When using cotton
1 Attach new cotton to the body with the attachment ring.
●
For attaching a cotton puff, see "Preparation before use."
2 Saturate the cotton with your regular toner.
Do not use milky lotion or a gel-like or thick toner.
●
●
Saturate the cotton with lotion to the extent that lotion permeates the back of the
cotton.
3 Press the power switch. (Fig. 10)
The level indicator lamp will be turned on, and "HOT MOISTURIZE" on the mode
●
indicator lamp will start flashing. If a lamp in another mode is flashing, press the mode
switch button to switch to "HOT MOISTURIZE."
When the "HOT CLEANSING" mode is finished, press the power switch and the
"HOT MOISTURIZE" mode will automatically be set.
Do not keep the cotton on the same area of skin, it is necessary to
move it around.
(Cause of problems with your skin or physical discomfort.)
※The spot sensor cannot senses the spot.
-9-
Advertisement
