Reversing The Door Handles - GE 14 Owner's Manual

Reversing the hardware.
Read these instructions completely and carefully.
Transfer Bottom Hinge to the Left
Remove the base grille (if your refrigerator
1
has one) by pulling it straight out.
Using a Torxdriver, move the bottom hinge
2
bracket (and shim glued to it) and plastic
washer from the right side to the left side.
Transfer Top Hinge to the Left
Interchange hinge (and the shim glued to it)
and screws at top right with screws at top left of
cabinet.
Do not tighten screws on hinge side at this time.
Some hinges have four holes. Which holes you
use for installing the hinge depends on which
side you install the hinge.
The outer edge of the hinge should be parallel to
the edge of the case for correct installation.

Reversing the door handles.

Read these instructions completely and carefully.
Transfer Fresh Food Door Handle
Remove the handle plug using a tape-tipped
1
putty knife under the edge, and remove the
screw underneath.
Remove the two screws holding the handle to
2
the top of the door.
Remove the handle.
3
Remove the screws from the right edge of the
4
door top and insert them into the handle
screw holes on the opposite side.
With tape-tipped putty knife or thin-blade
5
screwdriver, pry out the plug button from the
hinge hole on the left side of the door and
insert it into the hole on the opposite side
that was vacated by removal of the top hinge.
Pull the plug button from the front of the
6
door and transfer it to the opposite side.
20
Plastic Washer
Hinge Bracket
Installing the hinge on the left.
Installing the hinge on the right.
Top
Bottom
Plug Button
Screws for
Handle Holes
Plug Button
To reattach the handle on
the opposite side.