ABB Relion 670 Series Applications Manual page 538

Section 20
Station communication
SMPLLOST indicates that merging unit data are generated by internal substitution or one/more
channel's Quality is not good or merging unit is in Testmode/detailed quality=Test, IED is not in
test mode.
Using external clock for time synchronization
IEC/UCA 61850-9-2LE
IEC10000074 V2 EN-US
Figure 240: Setting example with external synchronization
Settings on the local HMI under Main menu/Configuration/Time/Synchronization/
TIMESYNCHGEN:1/IEC61850-9-2:
HwSyncSrc : set to PPS/IRIG-B depending on available outputs on the clock.
•
SyncLostMode : set to Block to block protection functions if time synchronization is lost.
•
SyncAccLevel : can be set to 4μs since this corresponds to a maximum phase angle error of
•
0.072 degrees at 50Hz.
fineSyncSource : should be set to IRIG-B if available from the clock. If PPS is used for
•
HWSyncSrc , "full-time" has to be acquired from another source. If station clock is on the local
area network (LAN) and has an sntp-server, this is one option.
Two status monitoring signals can be:
• SYNCH signal on the MUx function block indicates that protection functions are blocked due
to loss of internal time synchronization to the IED (that is loss of the hardware
• MUSYNCH signal on the MUx function block monitors the synchronization flag
the datastream and IED hardware time synchronization.
No time synchronization
532
This example is not valid when GPS time is used for differential protection, when
PTP is enabled or when the PMU report is used.
PPS / IRIG-B
IED
data
PPS
MU
This example is not valid when GPS time is used for differential protection, when
PTP is enabled or when the PMU report is used.
© Copyright 2017 ABB. All rights reserved
STATION
CLOCK
IEC10000074=2=en=Original.vsd
1MRK 511 401-UUS F
synchSrc ).
smpSynch in
Bay control REC670
Application manual