Table of Contents
Advertisement
Installing a Card in a Full-length Slot
Follow these steps to install an option card in one of the
full-length slots:
1.
Remove the retaining screw securing the option slot cover
to the computer, as shown below. (Keep the screw to secure
the option card to the computer.)
2.
Slide out the slot cover and set it aside. (Store it in a safe
place in case you remove the option card later.)
3.
Hold the card along the top corners and guide it into the
slot, as shown below. (If you are installing a full-length
card, insert the front edge of the card into the
corresponding guide inside the computer's front panel.)
Once the connectors reach the slot, push the card in firmly
(but carefully) to insert it fully. You should feel it fit into
place. If the card does not go in smoothly, do not force it;
pull it all the way out and try again.
Installing and Removing Options
3 - 1 5
Advertisement
Table of Contents
