Table of Contents
Advertisement
■Wiring Fixation Cramp Installation Method
Use the wiring fixation cramp to prevent disconnection of the USB and power supply
connectors.
1) Plug-in the USB and power supply connector into the sensor unit.
2) Cross the cables and attach the wiring fixation cramp at the intersection.
Use the provided M3 screw to fix the cramp to the sensor unit.
※Avoid over-bending the cables during fixation. It may cause disconnections in the cable,
resulting in smoke emissions or result in a fire.
■Fall Prevention Wire Installation Method
Always use the fall prevention wire to avoid falls when installing the sensor unit in high places.
Please work with care in high place.
1) Wrap the wire around a secure place (that could stop a fall) and
insert one extremity's ring into the other.
2) Attach the ring that went through the other to the gutter located at the upper-left
of the sensor unit.
3) Place the provided washer above it and fix it with the provided M3 screw.
(Do not press down too strongly the washer on the wire. It might result in a
rupture of the wire.)
※The fall prevention wire's length is 50cm. Always ensure the sensor unit is fixed
in a safe position and adjust the length accordingly.
Washer (included)
M3 screw (included)
Power supply
M3 screw
(included)
Wiring fixation cramp (included)
Fall prevention wire
(included)
Fall prevention wire fixation
PC
Screw for wiring fixation
cramp set-up (included)
8/15
Advertisement
Table of Contents
