Table of Contents
Advertisement
▪
Remove the top locking pieces, then replace the failsafe configuration securely and
invert the top locking pieces over the threads of the isolators as shown in Figure
M-42.
▪
Use the front isolator threads to store the bottom locking pieces.
▪
Replace all nuts and washers as shown in Figure M-43 and fasten securely with a 10
mm spanner.
Figure M-42: Inverted top locking piece
▪
Surplus nuts and washers can be stored with the spares or attached to the bolts at
the top of the left and right brackets as shown in Figure M-44.
Note:
Nuts and washers must be retained for future use.
Figure M-44: Surplus nuts & washers stored securely on bracket bolts
MA-005 - Minitrans Installation Manual - Rev 4.5
Figure M-43: Bottom locking piece
13-Aug-20
Page 85 of 86
Advertisement
Table of Contents
