A.
B.
C.
D.
Figure 8-4: Product connections - bottom view
8.3.2 Fitting instructions
1.
Insert one end of the tubing into the Swagelok or Ham-Let fitting body as shown in
Figure 8-5.
Figure 8-5: Fitting body and tubing
2.
Ensure that the tubing rests firmly on the shoulder of the fitting body and that the
nut is finger-tight.
3.
Mark the nut with a fine-tipped permanent marker at the 6 o'clock position as
shown in Figure 8-6.
Figure 8-6: Nut at 6 o'clock position
4.
While holding the fitting body steady, tighten the nut 1 and a 1/4 turns to the 9
o'clock position as shown in Figure 8-7.
Figure 8-7: Nut at 9 o'clock position
MA-005 - Minitrans Installation Manual - Rev 4.5
Blank cable grommet
Power-in gland
M8 earth connection point
Cable grommets
E.
Ambient temperature sensor
F.
Condensation plug
G.
Oil out
H.
Oil in
13-Aug-20
Page 25 of 86