Page 2
Items Contents Dimensions ( W × H × D ) 66.0 cm × 48.83 cm × 27.86 cm [66.0 cm × 44.0 cm × 9.0 cm (Without stand)] Mass 9.2 kg [8.2 kg (Without stand)] Power Input AC220V - AC240 V, 50 Hz Power Consumption 95 W (Standby: 17.3 W) TV RF System...
SECTION 1 PRECAUTION SAFETY PRECAUTIONS (1) The design of this product contains special hardware, (6) Isolation Check (Safety for Electrical Shock Hazard) many circuits and components specially for safety After re-assembling the product, always perform an isola- purposes. For continued protection, no changes should be tion check on the exposed metal parts of the cabinet (an- made to the original design unless authorized in writing by tenna terminals, video/audio input and output terminals,...
Page 4
INSTALLATION 1.2.1 ATTACH THE STAND TO THE TV 1.2.4 INSTALLATION REQUIREMENTS When installing the unit on the floor, it is required to attach the Ensure that the minimal distance is maintained, as specified supplied stand. below, between the unit with and the surrounding walls, as well To attach the stand to the TV, follow the procedure below.
Page 5
HANDLING LCD PANEL 1.3.1 PRECAUTIONS FOR TRANSPORTATION 1.3.2 OPTICAL FILTER (ON THE FRONT OF THE LCD PANEL) When transporting the unit, pressure exerted on the internal LCD (1) Avoid placing the unit under direct sunlight over a panel due to improper handling (such as tossing and dropping) prolonged period of time.
SECTION 2 SPECIFIC SERVICE INSTRUCTIONS FEATURES DIGITAL TUNER PICTURE MODE This TV can receive both DVB-C(Digital cable broadcasting) and This function can adjust the picture settings automatically. Analogue terrestrial broadcasting. There are BRIGHT, STANDARD, SOFT and MANUAL in the PICTURE MODE. HDMI INPUT By connecting a HDMI compatible device, high definition ZOOM...
Page 7
TECHNICAL INFORMATION 2.3.1 LCD PANEL This unit uses the flat type panel LCD (Liquid Crystal Display) panel that occupies as little space as possible, instead of the conventional CRT (Cathode Ray Tube), as a display unit. Since the unit has the two polarizing filter that are at right angles to each other, the unit adopts "normally black" mode, where light does not pass through the polarizing filter and the screen is black when no voltage is applied to the liquid crystals.
SECTION 3 DISASSEMBLY CAUTION AT DISASSEMBLY • Make sure that the power cord is disconnected from the outlet. • Pay special attention not to break or damage the parts. • Make sure that there is no bent or stain on the connectors before inserting, and firmly insert the connectors. •...
Page 9
SIDE SHIELD REAR COVER SMART DTV GUIDE SMART MPEG PWB POWER UNIT MAIN PWB POWER BRACKET INVERTER MAIN SHIELD PWB COVER STAND PANEL BRACKET LCD PANEL INVERTER PANEL BLUE LED MODULE BRACKET SPEAKER IR PWB CONTROL KNOB SPEAKER FRONT KEY PWB CONTROL CABINET BASE...
Page 10
MEMORY IC REPLACEMENT • This model uses the memory IC. • This memory IC stores data for proper operation of the video and drive circuits. • When replacing, be sure to use an IC containing this (initial value) data. 3.3.1 MEMORY IC REPLACEMENT PROCEDURE 1.
Page 11
3.3.3 SETTINGS OF FACTORY SHIPMENT 3.3.3.1 BUTTON OPERATION 3.3.3.2 REMOTE CONTROL DIRECT OPERATION Setting item Setting position Setting item Setting position POWER CHANNEL CHANNEL VOLUME VOLUME ZOOM AUTO SUB POWER 3.3.3.3 REMOTE CONTROL MENU OPERATION (1) Picture (4) Feature Setting item Setting position Setting item Setting position...
Page 12
REPLACEMENT OF CHIP COMPONENT 3.4.1 CAUTIONS (1) Avoid heating for more than 3 seconds. (2) Do not rub the electrodes and the resist parts of the pattern. (3) When removing a chip part, melt the solder adequately. (4) Do not reuse a chip part after removing it. 3.4.2 SOLDERING IRON (1) Use a high insulation soldering iron with a thin pointed end of it.
SECTION 4 ADJUSTMENT ADJUSTMENT PREPARATION (1) This TV is adjusted by using REMOTE CONTROL UNIT. (2) The adjustment using the REMOTE CONTROL UNIT is made on the basis of the initial setting values. The setting values which adjust the screen to the optimum condition can be different from the initial setting values. (3) Make sure that connection is correctly made AC to AC power source.
4.5.3 CHANGE AND MEMORY OF SETTING VALUE 4.5.4 FACTORY MODE SELECT KEY LOCATION SELECTION OF SETTING ITEM • [FUNCTION / ] key. For scrolling up / down the setting items. • [FUNCTION / ] key. For select the setting items. [Function / ] key CHANGE OF SETTING VALUE (DATA) [FUNCTION...
Page 15
PARTS LIST Preliminary CAUTION The parts identified by the symbol are important for the safety . Whenever replacing these parts, be sure to use specified ones to secure the safety. The parts not indicated in this Parts List and those which are filled with lines --- in the Parts No. columns will not be supplied. P.W.
Page 16
IR P.W. BOARD ASS'Y (HU-72200001) ......................3-9 KEY P.W. BOARD ASS'Y (HU-72200002) ...................... 3-10 PACKING ................................... 3-11 PACKING PARTS LIST ............................. 3-11 USING P.W. BOARD & REMOTE CONTROL UNIT P.W.B ASS'Y name LT-26DC1BH/AX MAIN P.W.B HU-71100007 MPEG P.W.B HU-71100009 IR P.W.B HU-72200001 KEY P.W.B...
Page 18
PRINTED WIRING BOARD PARTS LIST MAIN P.W. BOARD ASS'Y (HU-71100007) Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local HU-001060250 C CAPACITOR 0.1uF 16V K HU-001060250 C CAPACITOR 0.1uF 16V K ------------ Not supply HU-001060250 C CAPACITOR 0.1uF 16V K...
Page 19
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local C233 HU-001060219 C CAPACITOR 1000pF 50V K C631 HU-001060250 C CAPACITOR 0.1uF 16V K C234 HU-001060219 C CAPACITOR 1000pF 50V K C632 HU-001060236 C CAPACITOR 10uF 25V C235 HU-001060236...
Page 20
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local HU-002000417 MG RESISTOR 4.7kΩ R356 HU-002000433 MG RESISTOR 0Ω HU-002000417 MG RESISTOR 4.7kΩ R357 HU-002000433 MG RESISTOR 0Ω HU-002000417 MG RESISTOR 4.7kΩ R370 HU-002000405 MG RESISTOR 1kΩ...
Page 21
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local R669 HU-002000437 MG RESISTOR 10kΩ L378 HU-011000056 INDUCTOR 1.8uH R680 HU-002000437 MG RESISTOR 10kΩ L379 HU-011000056 INDUCTOR 1.8uH R681 HU-002000417 MG RESISTOR 4.7kΩ L380 HU-011000056 INDUCTOR 1.8uH...
Page 22
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local HU-005000900 CRYSTAL 20.25MHz C334 HU-001060250 C CAPACITOR 0.1uF 16V K Y470 HU-005000890 CRYSTAL 14.31818MHz C335 HU-001071223 E CAPACITOR 100uF 16V Y800 HU-005000940 CRYSTAL 16MHz C336 HU-001060250 C CAPACITOR...
Page 23
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local HU-002000096 MG RESISTOR 10kΩ R808 HU-002000547 MG RESISTOR 120Ω HU-002000417 MG RESISTOR 4.7kΩ R809 HU-002001002 MG RESISTOR 56Ω HU-002000538 MG RESISTOR 120Ω R900 HU-002000433 MG RESISTOR 0Ω...
Page 25
PACKING 13 18 30 PACKING PARTS LIST Ref.No. Part No. Part Name Description Local ------------ CARTON BOX Not supply ------------ CUSHION Not supply HU-0320200064 REMOTE CONTROL UNIT RM-C2503 ------------ BATTERY AAA/R03(x2) HU-2000000130 INST BOOK English/French/German/Dutch ------------ WARRANTY CARD HU-2030000014PT HU-2000700098 CAUTION SHEET...
Page 27
LT-26DC1BH STANDARD CIRCUIT DIAGRAM NOTE ON USING CIRCUIT DIAGRAMS 1.SAFETY Type No indication : Ceramic capacitor The components identified by the symbol and shading are : Metalized mylar capacitor critical for safety. For continued safety replace safety ciritical : Polypropylene capacitor components only with manufactures recommended parts.
Page 28
MAIN PWB PATTERN ..........................2-91 MPEG PWB PATTERN ..........................2-95 IR PWB PATTERN ............................ 2-96 KEY PWB PATTERN ..........................2-96 USING P.W. BOARD P.W.B ASS Y name LT-26DC1BH/AX MAIN P.W. BOARD HU-71200007 MPEG P.W. BOARD HU-71200009 IR P.W. BOARD HU-72200001 KEY P.W.
WIRING DIAGRAM LCD PANEL UNIT [LCD CONTROL PWB] LCD PANEL UNIT [INVERTER PWB] DIGITAL TUNER JP770 SMART DTV PWB KEY PWB MPEG PWB JP900 JP660 JP710 250V/6.3A JP680 JP630 POWER UNIT JP681 AC INLET JP682 JP581 ANALOG TUNER JP683 MAIN PWB IR PWB BLUE LED MODULE SPEAKER(L)
Page 78
Victor Company of Japan, Limited Display Division 12, 3-chome, Moriya-cho, Kanagawa-ku, Yokohama-city, Kanagawa-prefecture, 221-8528, Japan (No.YA693<Rev.001>) Printed in Japan...