Miele EVS 7010 Operating And Installation Instructions page 57

Installing and connecting the drawer
 Check that the air filter is installed
and the safety screws have been re-
moved from the back of the drawer
(see "Installation – Building in").
 Connect the power cord to the
drawer.
 Slide the closed drawer into the
housing unit. When doing so, make
sure that the power cord does not get
trapped or damaged.
 Align the drawer at right angles.
 Open the drawer and secure it to the
right and left-hand side walls of the
housing unit with the 2 wood screws
supplied 1/8" x 1" (3.5 x 25 mm).
 Remove the foam adhesive label from
the glass lid.
 Remove the 4 foam adhesive labels
from the back of the front panel on
the right and left-hand sides.
 Connect the drawer to the power
supply.
When the drawer is first connected, or
after a power failure, all of the sensor
controls and indicators will light up for
approx. 10 seconds for testing (initial-
ization). As soon as they go out, the
drawer is ready for use.
 When installing the combination ap-
pliance, protect the top edge of the
front panel from abrasive marks.
 Install the combination appliance in
accordance with the operating and
installation instructions supplied with
it.
Installation
57