Advertisement
Removing the Splined Insert
Locking compound solvent: Loctite® 768™ solvent
(59 ml (2 oz) Henkel Part No. 768 X-NMS)
1.
Restrain the reel to remove the existing splined
insert; refer to
Restraining the Reel for Removing
Threaded Inserts (page
2.
Using the reel driveshaft tool (Toro Part No.
TOR4074), remove and discard the existing
splined inserts from each end of the reel
driveshaft
(Figure
Important:
The splined insert at the left side
of the cutting unit has left-hand threads. The
splined insert at the right side of the cutting
unit has right-hand threads.
1. Reel driveshaft
3.
Use Loctite 768 solvent and a wire brush to clean
the threads in each end of the reel driveshaft.
4.
Dry the reel-driveshaft threads.
21).
3).
Figure 6
2. Splined insert
Assembling the Extended Splined
Insert
Hydraulic Motor Side
Note:
The splined insert at the left side of the cutting
unit has left-hand threads. The splined insert at the
right side of the cutting unit has right-hand threads.
1.
Restrain the reel to install the extended splined
insert; refer to
Threaded Inserts (page
2.
Apply medium-strength thread-locking
compound (such as Blue Loctite® 243) to the
threads in the hydraulic motor end of the reel
driveshaft.
g356735
1. Extended splined insert
3.
Assemble the extended splined insert into the
end of the reel driveshaft
4.
Torque the insert to 115 to 128 N∙m (85 to 95
ft-lb).
5.
Allow the thread-locking compound to cure for
15 minutes.
6
Restraining the Reel for Installing
22).
Figure 7
2. Reel driveshaft
(Figure
7).
g356732
Advertisement
